A, Features:

1.Easy setting: easy operation.

2 It (CAR- -30A) is designed for Cars with the operating voltage 4V-14V.

3 Automatic power cut-off.(when the radio signal loses for more than 3 seconds ,the power will be automatically cut off.)

4 BEC (5V/2A) provides power to receiver and servos.

5 Over-heat protection. The power will be cut-off as temperature reaches 110 degree.

6 Programming-Box (prog-box)can make ESC CAR- -30A setting easier and extend the possibilities of ESC settings.

B, Factory Default Setting:

1 Forward / brake/ reverse mode

2 Timing mode1 (0-7’)

2 Cut-off voltage mode 1 (Intellectual cut-off for Ni-MH-CD battery)

C, operation-for CAR- 30A without Prog-Box

1 connection ( connect the motor & ESC / connect the receiver & ESC)

2 Programming and Start-Up:

1) Setting the Forward /brake/reverse or Forward/brake mode: Note-Factory Default Setting: Forward/brake/reverse

How to change the forward/brake/reverse on/off mode:

l         Switch “on” the transmitter and move the stick to “full throttle” (highest position)

l         Connect the main power pack to ESC

l         Wait for 5 seconds, you will hear 4 beeps

l         Move the throttle stick to position “close” (middle position)

l         After moving you will hear 1 “beep” that means forward/brake on/reverse off; or2 “beep” that means forward/brake /reverse on –(now the setting is saved)

Note: if you want to change the mode again or set Timing mode, disconnect the motor battery pack and then repeat the procedure.

2) timing more setting (default setting :timing mode1,0-7)

 How to change the Timing mode

l         Switch “on” the transmitter and move the stick to “full throttle” (highest position)

l         Connect the main power pack to ESC.

l         Wait 5 seconds, you will hear 4 beeps, do not move the throttle stick

l         Wait 5 seconds, you will hear 5 “ Single Beeps” (Timing mode 1, 0-7); then “ double Beeps” (Timing mode 2, 8-18); then “ thrice Beeps” (Timing mode3, 19-24); and then “ Quartet Beeps” (Timing mode 4, 25-30)

l         Swiftly move the throttle stick to position “close” ( middle position) after the first 5 “single beeps”(if choosing mode 1) :or after the 5 “double beeps”(if choosing mode 2); the 5 “thrice beeps”(if choosing mode 3);etc---------------------------(now the timing mode setting is saved)

l         Hear 1 “single beep” (Forward /brake on; reverse off) or 2 (Forward /brake on; reverse on).No confirmation sound for timing